Ulti-Boom Pro Series Mic Booms

Microphone booms have long been a necessary evil. Fiddly knobs and phony features like molded “grips” that only look like counterweights just add symptoms to the underlying disease: the dreaded Droopy Microphone Syndrome. DMS has plagued engineers and musicians for decades, with little relief in sight. You know the story: you finally get the mic set where you want it, only to have the inner tube of the boom turn and the mic flops downward, or the entire boom sags down toward the floor, forcing you to crank the knobs until they strip or break. Followed by duct tape, rubber bands, and then buying another boom to replace the one you bent while beating the dumpster with it in a blind rage.

We don’t want any of that to happen, and we don’t want you to hurt yourself. So we sat down and peered into our microscopes until we finally found a solution. Ultimate Support is proud to announce the Ulti-Boom Pro: the cure for Droopy Mic Syndrome. It starts with a telescoping D-Tube and StableLock™ lever for a quick adjustment that locks and can’t turn. Then there is the One-Touch Z-Knob, that allows four degrees of freedom with a single knob. The clutch mechanism has a patented ball joint and dual disc-brake system that holds the mic where you put it. Finally, a die-cast, threaded counterweight brings the balance while the architectural anodized finish keeps the boom looking great. Once you’ve used one, your old inferior booms will seem like the dinosaurs they are. Dumpsters everywhere, beware…